%general-entities; ]> Setting Host and Target During the building of the cross-compile tools you will need to set a few variables that will be dependent on your particular needs. The first variable will be the triplet of the HOST machine. You will need to set the CHOST triplet to match your particular needs. To set this information you can issue the following command: export CLFS_HOST="$(echo $MACHTYPE | \ sed "s/$(echo $MACHTYPE | cut -d- -f2)/cross/")" Now you will need to set the target triplet for the target architecture. You can do this by running the same command as above, just running it on the target machine. If you can't run the command on the target machine, you can use the table at the bottom of this page. Set the command using the method listed below: export CLFS_TARGET="{target triplet}" Now we will add these to ~/.bashrc, just in case you have to exit and restart building later: echo export CLFS_HOST=\""${CLFS_HOST}\"" >> ~/.bashrc echo export CLFS_TARGET=\""${CLFS_TARGET}\"" >> ~/.bashrc Processor Target Triplet 486 Compatibles i486-pc-linux-uclibc Pentium, K6, 586 Compatibles i586-pc-linux-uclibc Pentium II, Pentium III, Pentium 4 i686-pc-linux-uclibc Athlon, Duron i686-pc-linux-uclibc